HEMPALIN ENAMEL 52140

Description:
HEMPALIN ENAMEL 52140 is a glossy alkyd enamel which forms a weather resistant coating. It is lexible and resistant to salt water and spillage of mineral oil and other aliphatic hydrocarbons.

Recommended use:
As a general purpose finishing coat in alkyd systems on exterior and interior steel and woodwork in ildly to moderately corrosive environment. As a finishing coat in engine rooms including tank tops,main engines and auxiliary machinery.

Service temperature:
Maximum, dry exposure only: 120°C/248°F (These temperatures may cause yellowing/discolouration.)

Certificates/Approvals:
Approved as a low flame spread material when used as part of a predefined paint system. Please refer o “Declaration of Conformity” on www.Hempel.com for further details.
Complies with EU Directive 2004/42/EC: subcategory i.

Availability:
Part of Group Assortment. Local availability subject to confirmation.

PHYSICAL CONSTANTS:
Shade nos/Colours:10000* / White.
Finish:Glossy
Volume solids, %:46 ± 1
Theoretical spreading rate：15.3 m2/l [613.5 sq.ft./US gallon] - 30 micron/1.2 mils
Flash point：°C [100.4 °F]
Specific gravity：1.1 kg/litre [9 lbs/US gallon]
Surface dry：2.5 approx. hour(s) 20°C/68°F
Dry to touch：6 - 8 hour(s) 20°C/68°F
VOC content：425 g/l [3.5 lbs/US gallon]
                     *wide range of colours available via Hempel's MULTI-TINT system.

APPLICATION DETAILS:
Application method：Airless spray / Air spray / Brush
Thinner (max.vol.)：08230 (5%) / 08230 (15%) / 08230 (5%) see REMARKS overleaf
Nozzle orifice：0.018 "
Nozzle pressure：150 bar [2175 psi]
                          (Airless spray data are indicative and subject to adjustment)
Cleaning of tools：HEMPEL'S THINNER 08230
Indicated film thickness, dry：30 micron [1.2 mils]
Indicated film thickness, wet：75 micron [3 mils]
Overcoat interval, min：see REMARKS overleaf
Overcoat interval, max：see REMARKS overleaf
Safety：Handle with care. Before and during use, observe all safety labels on packaging and paint containers,consult HEMPEL Safety Data Sheets and follow all local or national safety regulations.

SURFACE PREPARATION:
New steel:
Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other ontaminants by high pressure fresh water cleaning. Power tool cleaning to St 3 or abrasive blasting to a 2 (ISO 8501-1:2007). Prime with:HEMPALIN
Repair and maintenance:
Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Remove all rust and loose material by abrasive blasting or power tool cleaning. Dust off residues. Prime with: HEMPALIN. Touch up bare spots with: HEMPALIN ENAMEL 52140.

APPLICATION CONDITIONS:
Apply only on a dry and clean surface with a temperature above the dew point to avoid condensation.In confined spaces provide adequate ventilation during application and drying.

PRECEDING COAT:
According to specification. Recommended systems are: HEMPALIN PRIMER 12050 or HEMPALIN RIMER HI-BUILD 13200 or HEMPALIN UNDERCOAT 42460

SUBSEQUENT COAT:
None.

返回